This method assumes the top and bottom plates are already in place.
- Use a laser measure like the one shown below. In this example, the reading shows 8′ 11″ 5/16″. If you prefer precision to 1/8 of an inch, you may be able to change the precision settings in your laser measure.
Make sure the laser dot is on the surface of the distance you want to measure.
2. Then, using a measure, mark that length on your 2×4 wood.
3. Use a carpenter square to draw a straight line at that mark
4. Cut the wood at that line using a miter saw.
If you want to dry-fit your studs before permanently fastening them with nails, you can use A34 metal brackets with screws.
